خوش آمدید

Introduction of Pneumatic Tools Pneumatic tools are mainly a tool that uses compressed air to drive a pneumatic motor to output kinetic energy to the outside. According to its basic working methods, it can be divided into: 1. Rotary type (eccentric movable vane type). 2. Reciprocating (volumetric piston type) general pneumatic tools are mainly composed of power output parts, operation form conversion parts, intake and exhaust parts,  operation opening and stop control parts, tool housings and other main parts. Of course, the operation of pneumatic tools must also have Energy supply part, air filtration and air pressure regulation part, tool accessories, etc. Airless Electric Paint Sprayer 1. Advantages of pneumatic tools: 1. Long service life of pneumatic components;

2. High movement speed of pneumatic actuators; 3. Simple structure, convenient maintenance and low cost; 4. Small gas viscosity and flow resistance loss, which is convenient for centralized gas supply 5. The air is easy to obtain and the working pressure is low, and the used air can be discharged on the spot, without the need for recycling pipes; Reliable work in dusty environment, slight leakage will not pollute the environment, no fire and explosion hazard, safe to use;

7. The execution output of pneumatic components is smaller than that of hydraulic pressure, the movement is faster, the adaptability is strong, and it can be used in easy, explosive, It can work in harsh environments with heavy sinking, humidity and impact, without polluting the environment, with long working life, simple structure, easy maintenance and low price. 2. Matters needing attention:

1. Impact-type pneumatic tools Impact-type pneumatic tools include: pneumatic picks, pneumatic shovels, pneumatic tamping machines, pneumatic riveting machines, needle-bundle pneumatic rust removers and other impact-type pneumatic tools. It is forbidden to use them under any air pressure. Do not start the machine if it is not in contact with the workpiece by hitting its working tools (pick drill, shovel head, pounding head, socket head, etc.), so as to avoid the hammer body or working tools hitting and hurting people. After stopping the operation, the machine itself should not be used The working tools of the tool locking device, such as the shovel head, the socket head, etc., should be removed, and the nails of the pneumatic nailing machine should also be removed to ensure safety.

2. Rotary pneumatic tools Rotary pneumatic tools include: pneumatic drills, pneumatic grinders, pneumatic triggers and pneumatic screwdrivers, pneumatic tapping machines, pneumatic polishing machines, pneumatic strapping machines and rotary pneumatic rust removers, etc. using quick-change joints It is best to use a quick-change fitting that automatically closes the air intake when the coection is discoected. If you use a quick-change fitting that does not automatically close the air intake, the inlet valve of the pipeline should be closed before the coector is discoected. Discoect the quick-coect fitting after exhausting the remaining air pressure in the hose to avoid accidents. △ When loading and unloading drill bits, taps,

reamers and other working tools, the air drill and pneumatic tapping machine must be discoected from the air supply line, or the compressed air of the air supply hose must be cut off and exhausted (such as using a The machine with valve locking device only locks the intake valve). △ For pneumatic triggers and pneumatic screwdrivers, always check whether the cylindrical pin and rubber ring coecting the trigger shaft of the pneumatic trigger and the sleeve are intact, so as to avoid accidents caused by the flying of the sleeve during use. Do not run dry after the screwdriver bit is installed in the machine.